Toyota Yaris: Window / Glass / Power Window Control System
ComponentsCOMPONENTS ILLUSTRATION
*1 POWER WINDOW REGULATOR SWITCH ASSEMBLY *2 FRONT ARMREST BASE UPPER PANEL *3 POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE UPPER PANEL - - RemovalREMOVAL PROCEDURE 1...
PRECAUTION POWER WINDOW CONTROL SYSTEM PRECAUTIONS NOTICE:
The power window control system uses the LIN communication system and CAN communication system...
Other information:
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL REAR DISC (a) Check the identification marks and confirm the installation positions...
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine unit removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Engine assembly
Cylinder head sub-assembly
Camshaft (for intake or exhaust camshaft)
Camshaft timing gear assembly
Camshaft timing exhaust gear assembly
Fuel injector assembly
Fuel pump (for low pressure side)
Fuel pump assembly (for high pressure side)
Fuel pressure sensor (for low pressure side)
Fuel pressure sensor (for high pressure side)
Spark plug
Ignition coil assembly
Air intake system parts
Exhaust system parts
Turbocharger sub-assembly
Inspection after repair
Poor idle, etc...
Categories
WARNING
When removing the fuel-filler cap, loosen the cap slightly and wait
for
any hissing to stop, then remove it
Fuel spray is dangerous. Fuel can burn skin and eyes and cause illness
if
ingested. Fuel spray is released when there is pressure in the fuel tank and
the fuel-filler cap is removed too quickly.
read more