Toyota Yaris: Networking / Lin Communication System

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual / Power Source & Network / Networking / Lin Communication System

Power Integration No.1 System Missing Message (B235287,B235587,B235787-B235987)

DESCRIPTION This DTC is stored when CXPI communication between the semiconductor power integration ECU, power distribution box assembly, windshield wiper relay assembly or light control LED ECU and main body ECU (multiplex network body ECU) stops for 10 seconds or more...

Parts Location

PARTS LOCATION ILLUSTRATION *1 FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY (DRIVER DOOR) *2 FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY (FRONT PASSENGER DOOR) ILLUSTRATION *1 MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY *2 POWER DISTRIBUTION BOX ASSEMBLY - DOOR F/R FUSE - DOOR F/L FUSE - DOOR R/L FUSE - DOOR R/R FUSE - STRG LOCK FUSE - ECU-B NO...

Other information:

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Zero Point Calibration of Steering Angle Sensor Not Acquired (X20D8)


DESCRIPTION Code Tester Display Measurement Item Trouble Area RoB Output from X20D8 Zero Point Calibration of Steering Angle Sensor Not Acquired History of being unable to obtain the steering angle zero point Sensor installation Yaw rate and acceleration sensor (airbag sensor assembly) Brake CAUTION / NOTICE / HINT NOTICE: This Vehicle Control History (RoB) may be output during situations when the steering angle sensor zero point calibration temporarily cannot be acquired, such as when the stop light is stuck ON...

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Ignition Circuit


DESCRIPTION A direct ignition system is used on this vehicle. The direct ignition system is a 1 cylinder ignition system which ignites one cylinder with one ignition coil. In the 1 cylinder ignition system, one spark plug is connected to the end of the secondary winding...

Categories

Turning the Engine Off

Stop the vehicle completely. Manual transaxle: Shift into neutral and set the parking brake.

Automatic transaxle: Shift the selector lever to the P position and set the parking brake.

Press the push button start to turn off the engine. The ignition position is off.

read more

 
Copyright © 2025 www.toyaris4.com