Toyota Yaris: Lin Communication System / Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Check for DTCs.
Body Electrical > Main Body > Trouble Codes Body Electrical > Smart Key > Trouble Codes Body Electrical > Power Source Control > Trouble Codes
(b) Check the details of the DTCs.
CLEAR DTC
(a) Clear the DTCs.
Body Electrical > Main Body > Clear DTCs Body Electrical > Smart Key > Clear DTCs Body Electrical > Power Source Control > Clear DTCs
DIAGNOSIS SYSTEM DESCRIPTION The main body ECU (multiplex network body ECU) and certification ECU (smart key ECU assembly) control the LIN communication system...
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts...
Other information:
DESCRIPTION When the stop and start system does not operate, check whether the operation is prohibited because the auxiliary battery conditions are not met. Data List items Hood Courtesy Switch Auxiliary Battery Current Auxiliary Battery Fluid Temperature (Start) Auxiliary Battery Fluid Temperature Idling Stop Rate Total Idling Stop Rate Integrated Current Status of Auxiliary Battery Charge Control Minimum Voltage (Cranking) Minimum Voltage (Starter Solenoid Engagement) State of BBC Stop&Start Operating Permission (Power Management) Stop&Start Operating Permission (Minimum Voltage (Starter Solenoid Engagement)) Stop&Start Operating Permission (Minimum Voltage (Cranking)) Stop&Start Operating Permission (Integrated Current) Stop&Start Operating Prohibition (Jump Start) Stop&Start Operating Prohibition (Manual Start for the First Time) Auxiliary Battery Type Ambient Temperature Alternator Status NOTICE: If the Data List item Stop&Start Operating Permission (Power Management) is "NG" even after correcting a certain problem using the diagnostic troubleshooting procedures, the problem may be due to the auxiliary battery charge amount being temporarily low or the auxiliary battery may be deteriorated...
DESCRIPTION The smart door control receiver assembly is used to receive radio waves related to the entry functions of the electrical key transmitter sub-assembly. The certification ECU (smart key ECU assembly) decodes the requested electrical key transmitter sub-assembly operation by identifying a key code based on the radio waves received via the smart door control receiver assembly...
Categories
The fuel gauge shows approximately how much fuel is remaining in
the tank when the ignition is switched ON. We recommend keeping
the tank over 1/4 full.

Full
1/4 Full
Empty
read more