Toyota Yaris: Steering Column / Steering Column Assembly
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table...
COMPONENTS ILLUSTRATION
*1 STEERING WHEEL ASSEMBLY - -
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft...
Other information:
The Low Speed Pre-Collision System laser sensor is installed at
the top of the windshield near the rearview mirror.
Always keep the surface of the
windshield around the laser sensor clean to assure proper operation of the Low
Speed PreCollision System...
TERMINALS OF ECU COMBINATION METER ASSEMBLY
(a) Measure the voltage and resistance and check for pulses according to the value(s) in the table below. Terminal No. (Symbol) Terminal Description Condition Specified Condition H6-1 (B) - Body ground Auxiliary battery Ignition switch off 11 to 14 V H6-9 (CANH) CAN communication line - - H6-10 (MSCL) Local bus communication line - - H6-11 (TX1-) - Body ground Outside temperature sensor signal - - H6-13 (FR2) - H6-24 (FE&B) Fuel level signal Ignition switch ON, fuel level full → low (fuel level warning light on) Pulse generation (See waveform 3) H6-14 (FV) - Body ground Fuel sender gauge (Power source) Ignition switch ON Pulse generation (See waveform 1) H6-15 (MSTI) - Body ground Steering pad switch signal Ignition switch ON, up, down, right and left switches on steering pad switch not pushed 4...
Categories
WARNING
When removing the fuel-filler cap, loosen the cap slightly and wait
for
any hissing to stop, then remove it
Fuel spray is dangerous. Fuel can burn skin and eyes and cause illness
if
ingested. Fuel spray is released when there is pressure in the fuel tank and
the fuel-filler cap is removed too quickly.
read more