Toyota Yaris: Drive Shaft / Propeller Shaft / Rear Drive Shaft Assembly
Problem Symptoms TablePROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table...
COMPONENTS ILLUSTRATION
*1 REAR AXLE SHAFT NUT *2 REAR SPEED SENSOR *3 REAR FLEXIBLE HOSE *4 CAP *5 REAR STABILIZER LINK ASSEMBLY *6 REAR STABILIZER BAR *7 REAR COIL SPRING *8 REAR LOWER COIL SPRING INSULATOR *9 REAR NO...
Other information:
When the wipers no longer clean well, the blades are probably worn
or cracked.
Replace the wiper blades using the following procedure.
Raise the wiper arm and turn
the blade assembly to expose
the plastic locking clip.Compress the clip and slide the
assembly downward; then lift it
off the arm...
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the knock sensor removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of throttle body with motor assembly
Cleaning the deposits from the throttle body with motor assembly
Air leaks from intake system
Replacement of knock control sensor
Inspection after repair
Poor idle, etc...
Categories

Smart key
Auxiliary key
Key code number plate
To use the auxiliary key, press the knob and pull out the auxiliary key
from the smart key.

read more