Toyota Yaris: G16e-gts (fuel) / Fuel Injector (for Direct Injection)
COMPONENTS ILLUSTRATION
*1 FUEL INJECTOR ASSEMBLY *2 FUEL DELIVERY PIPE *3 FUEL INJECTOR SEAL *4 C-RING *5 NO. 3 FUEL INJECTOR BACK-UP RING *6 O-RING *7 NO...
Other information:
InspectionINSPECTION PROCEDURE 1. INSPECT NO.1 ELECTRONIC FUEL INJECTION MAIN RELAY (EFI-MAIN NO. 1) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 3 - 5 Auxiliary battery voltage not applied between terminals 1 and 2 10 kΩ or higher Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω If the result is not as specified, replace the No...
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced when repairing air leaks in the intake system are shown below...
Categories
WARNING
When removing the fuel-filler cap, loosen the cap slightly and wait
for
any hissing to stop, then remove it
Fuel spray is dangerous. Fuel can burn skin and eyes and cause illness
if
ingested. Fuel spray is released when there is pressure in the fuel tank and
the fuel-filler cap is removed too quickly.
read more