Toyota Yaris: Drive Shaft / Propeller Shaft / Front Drive Shaft Assembly
PrecautionPRECAUTION NOTICE OF REMOVING AND INSTALLING FRONT DRIVE SHAFT ASSEMBLY RH (a) When removing and installing the front drive shaft assembly RH, be sure to first drain all the transaxle oil and transfer oil...
COMPONENTS ILLUSTRATION
*1 NO. 1 ENGINE UNDER COVER ASSEMBLY *2 ENGINE UNDER COVER LH *3 ENGINE UNDER COVER RH - -
N*m (kgf*cm, ft...
Other information:
PRECAUTION PRECAUTION FOR BULB REPLACEMENT (a) Always prepare a new bulb for immediate replacement. While replacing the bulb, the lens may attract dust and moisture if the bulb is removed from the vehicle for a long time. (b) Always replace a bulb with another bulb of the same wattage...
INSTALLATION PROCEDURE 1. INSTALL CLUTCH PEDAL STROKE SENSOR ASSEMBLY (a) When installing a new clutch pedal stroke sensor assembly: NOTICE: Do not break the clutch pedal stroke sensor assembly lever set pin before being instructed to do so. (1) Install a new clutch pedal stroke sensor assembly to the clutch pedal support assembly with the 2 nuts...
Categories
The front and side supplemental restraint systems (SRS) include different
types of air bags. Please verify the different types of air bags
which are equipped on your vehicle by locating the “SRS AIRBAG”
location indicators. These indicators are visible in the area where the
air bags are installed.
The air bags are installed in the following locations:
The steering wheel hub (driver air bag)
The front passenger dashboard (front passenger air bag)
The outboard sides of the front seatbacks (side air bags)
The front and rear window pillars, and the roof edge along both
sides (curtain air bags)
read more