Toyota Yaris: Lighting System / Freeze Frame Data

Toyota Yaris XP210 (2020-2023) Reapir and Service Manual / Vehicle Exterior / Lighting (ext) / Lighting System / Freeze Frame Data

FREEZE FRAME DATA

FREEZE FRAME DATA

(a) Whenever a lighting system DTC is stored, the forward recognition camera stores the current vehicle state as freeze frame data.

CHECK FREEZE FRAME DATA

(a) Enter the following menus: Body Electrical / Front Recognition Camera (Front Lighting Control) / Trouble Codes.

Body Electrical > Front Recognition Camera (Front Lighting Control) > Trouble Codes

(b) Select a DTC to display its freeze frame data.

Body Electrical > Front Recognition Camera (Front Lighting Control)

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Total Distance Traveled

Actual driven distance

0 to 16777215

Roughly the same as the actual driven distance

-

Total Distance Traveled - Unit

Actual driven distance unit

km or mile

Displays the current actual driven distance unit

-

AHB/AHS Information

Automatic high beam system or adaptive high beam system specification information

Unknown, AHB or AHS

Unknown: Specification not stored

AHB: w/ Automatic High Beam System

AHS: w/ Adaptive High Beam System

-

CLEAR FREEZE FRAME DATA

NOTICE:

Clearing the DTCs will also clear the freeze frame data.

(a) Enter the following menus: Body Electrical / Front Recognition Camera (Front Lighting Control) / Clear DTCs.

Body Electrical > Front Recognition Camera (Front Lighting Control) > Clear DTCs

    Dtc Check / Clear

    DTC CHECK / CLEAR CHECK FOR DTC (MAIN BODY) (a) Check for DTCs. Body Electrical > Main Body > Trouble Codes CHECK FOR DTC (FRONT RECOGNITION CAMERA (FRONT LIGHTING CONTROL)) (a) Check for DTCs...

    Data List / Active Test

    DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not...

    Other information:

    Toyota Yaris XP210 (2020-2023) Reapir and Service Manual: Inspection


    INSPECTION PROCEDURE 1. INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Driver Side) (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition If the result is not as specified, replace the front seat inner belt assembly...

    Toyota Yaris XP210 (2020-2023) Reapir and Service Manual: Installation


    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP NOTICE: When installing a new roof drip side finish moulding clip, remove any double-sided tape remaining where the roof drip side finish moulding clips will be installed on the vehicle body and clean the vehicle body with a non-residue solvent...

    Categories

    Front Seat Belt Pretensioners

    The front seat belt pretensioners are designed to deploy in moderate or severe frontal, near frontal collisions.

    In addition, the pretensioners operate when a side collision or a rollover accident is detected. The pretensioners operate differently depending on what types of air bags are equipped. For more details about the seat belt pretensioner operation, refer to the SRS Air Bag Deployment Criteria.

    read more

     
    Copyright © 2023 www.toyaris4.com