Toyota Yaris: Lighting System / Dtc Check / Clear

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual / Vehicle Exterior / Lighting (ext) / Lighting System / Dtc Check / Clear

DTC CHECK / CLEAR

CHECK FOR DTC (MAIN BODY)

(a) Check for DTCs.

Body Electrical > Main Body > Trouble Codes

CHECK FOR DTC (FRONT RECOGNITION CAMERA (FRONT LIGHTING CONTROL))

(a) Check for DTCs.

Body Electrical > Front Recognition Camera (Front Lighting Control) > Trouble Codes

CLEAR DTC (MAIN BODY)

(a) Clear the DTCs.

Body Electrical > Main Body > Clear DTCs

CLEAR DTC (FRONT RECOGNITION CAMERA (FRONT LIGHTING CONTROL))

(a) Clear the DTCs.

Body Electrical > Front Recognition Camera (Front Lighting Control) > Clear DTCs

    Terminals Of Ecu

    TERMINALS OF ECU *1 Power Distribution Box Assembly *2 Main Body ECU (Multiplex Network Body ECU) CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND POWER DISTRIBUTION BOX ASSEMBLY (a) Remove the main body ECU (multiplex network body ECU) from the power distribution box assembly...

    Freeze Frame Data

    FREEZE FRAME DATA FREEZE FRAME DATA (a) Whenever a lighting system DTC is stored, the forward recognition camera stores the current vehicle state as freeze frame data...

    Other information:

    Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Disassembly


    DISASSEMBLY CAUTION / NOTICE / HINT NOTICE: When removing and installing the combination meter glass, make sure not to touch the display panel. Do not allow any dirt (fingerprints, grease, etc.) to adhere to the combination meter glass. If the glass is dirty, wipe it clean with a soft cloth...

    Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Throttle/Pedal Position Sensor/Switch "D" Circuit Short to Battery (P212012,P212014,P21201C,P21201F,P212099,P212512,P212514,P21251F,P21382B)


    DESCRIPTION HINT: These DTCs relate to the accelerator pedal position sensor. The accelerator pedal position sensor is built into the accelerator pedal sensor assembly and has 2 sensor circuits: VPA (main) and VPA2 (sub). This sensor is a non-contact type sensor and uses Hall-effect elements in order to yield accurate signals even in extreme driving conditions, such as at high speeds as well as very low speeds...

    Categories

    Turning the Engine Off

    Stop the vehicle completely. Manual transaxle: Shift into neutral and set the parking brake.

    Automatic transaxle: Shift the selector lever to the P position and set the parking brake.

    Press the push button start to turn off the engine. The ignition position is off.

    read more

     
    Copyright © 2025 www.toyaris4.com