Toyota Yaris: G16e-gts (engine Control) / Air Fuel Ratio Sensor (for Sensor 2)

Installation

INSTALLATION PROCEDURE 1. INSTALL AIR FUEL RATIO SENSOR (a) Using SST, install the air fuel ratio sensor to the front exhaust manifold. SST: 09224-00012 Torque: Specified tightening torque : 44 N·m {449 kgf·cm, 32 ft·lbf} NOTICE: If the air fuel ratio sensor has been struck or dropped, replace it...

Components

COMPONENTS ILLUSTRATION *1 NO. 2 AIR FUEL RATIO SENSOR *2 CENTER NO. 1 FLOOR BRACE *3 CENTER FRONT FLOOR BRACE *4 CENTER NO. 4 ENGINE UNDER COVER N*m (kgf*cm, ft...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Precaution

PRECAUTION PRECAUTION FOR SEMICONDUCTOR POWER INTEGRATION ECU (a) Do not remove or install the semiconductor power integration ECU and power distribution box assembly with the negative (-) auxiliary battery terminal connected. NOTICE: After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Front Passenger Side Electrical Antenna Circuit Open (B27A213)

DESCRIPTION The certification ECU (smart key ECU assembly) generates a request signal and transmits the signal to the front door outside handle assembly RH (electrical key antenna) at intervals of 0.25 seconds. For the front door outside handle assembly RH (electrical key antenna) to detect when the electrical key transmitter sub-assembly is brought close to the vehicle, a signal requesting a response from the electrical key transmitter sub-assembly is transmitted within approximately 1 m (3...