Toyota Yaris: G16e-gts (engine Control) / Air Fuel Ratio Sensor (for Sensor 1)

Accelerator Pedal

ComponentsCOMPONENTS ILLUSTRATION *1 ACCELERATOR PEDAL SENSOR ASSEMBLY *2 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft...

Components

COMPONENTS ILLUSTRATION *1 WATER GUARD PLATE LH *2 NO. 1 FRONT VENTILATOR SEAL *3 OUTER COWL TOP PANEL SUB-ASSEMBLY - - N*m (kgf*cm, ft...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: After Engine Stops due to Stop and Start System, Engine does not Restart

DESCRIPTION This is the troubleshooting procedure for situations where the engine does not restart after having been stopped by the stop and start system. For information on stop and start control, refer to the system description. Click here CAUTION / NOTICE / HINT PRECAUTIONS WHEN THE ENGINE STOP AND START ECU AND THE STARTER ASSEMBLY ARE REPLACED NOTICE: When the engine stop and start ECU is replaced, it is necessary to read the number of starter operations before replacement and store this number in the new engine stop and start ECU after replacement, and to perform external backup boost converter (eco run vehicle converter assembly) existence learning...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE NO. 1 DAMPER PLATE (a) Disengage the claw to remove the No. 1 damper plate. 2. INSTALL NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY (a) Remove the 2 screws and No. 1 blower damper servo sub-assembly. 3...