Toyota Yaris: Switches and Controls / Turn and Lane-Change Signals
The ignition must be switched ON to use the turn and lane-change
signals.
Use this switch to turn on the fog lights. The fog lights will
improve visibility at night and during foggy conditions.
The fog lights can be used when the ignition is switched ON...
Move the signal lever down (for a
left turn) or up (for a right turn) to
the stop position. The signal will
self-cancel after the turn is completed...
Other information:
This vehicle is equipped with an emission control system (the catalytic
converter is part of this system) that enables the vehicle to comply
with existing exhaust emissions requirements.
Under U.S. federal law, any modification to the original-equipment
emission
control system before the first sale and registration of a vehicle is
subject to
penalties...
PRECAUTION MAINTENANCE PRECAUTION (a) If the turbocharger sub-assembly is found to be defective, it must be replaced. Make sure to identify the cause of the problem including the conditions under which the turbocharger sub-assembly was used. Repair or replace the following as necessary: (1) Engine oil (level and quality) (2) Oil lines leading to the turbocharger sub-assembly (b) Be careful when removing and reinstalling the turbocharger sub-assembly...
Categories
The front seat belt pretensioners are designed to deploy in moderate or
severe frontal, near frontal collisions.
In addition, the pretensioners operate when a side collision or a rollover
accident is detected. The pretensioners operate differently
depending on what types of air bags are equipped. For more details
about the seat belt pretensioner operation, refer to the SRS Air Bag
Deployment Criteria.
read more