Toyota Yaris: Turn and Lane-Change Signals / Lane-Change Signals

Toyota Yaris XP210 (2020-2026) Owner's Manual / When Driving / Switches and Controls / Turn and Lane-Change Signals / Lane-Change Signals

Move the lever halfway toward the direction of the lane change—until the indicator flashes—and hold it there. It will return to the off position when released.

Turn Signals

Move the signal lever down (for a left turn) or up (for a right turn) to the stop position. The signal will self-cancel after the turn is completed...

Three-Flash Turn Signal

After releasing the turn signal lever, the turn signal indicator flashes 3 times. The operation can be cancelled by moving the lever in the direction opposite to which it was operated...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Problem Symptoms Table

PROBLEM SYMPTOMS TABLE NOTICE: When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Reassembly

REASSEMBLY PROCEDURE 1. INSTALL INPUT SHAFT FRONT BEARING INNER RACE (a) Using SST and a press, install the input shaft front bearing inner race to the input shaft. SST: 09608-00071 2. INSTALL INPUT SHAFT SNAP RING (a) Using a brass bar and hammer, tap a new input shaft snap ring to the input shaft...