Toyota Yaris: Drive Shaft / Propeller Shaft / Propeller Shaft Assembly

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1...

Components

COMPONENTS ILLUSTRATION *1 FRONT FLOOR COVER LH *2 FRONT FLOOR COVER RH *3 FRONT NO. 1 FLOOR HEAT INSULATOR SUB-ASSEMBLY - - N*m (kgf*cm, ft...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Camshaft Position Sensor "B" Bank 1 No Signal (sub) (P036500)

DESCRIPTION Refer to DTC P036511. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note P036500 Camshaft Position Sensor "B" Bank 1 No Signal (sub) No camshaft position sensor (for exhaust camshaft) signal to the sub ECM while engine running ECM Comes on SAE: P0365 MONITOR DESCRIPTION While the engine is running, when the EV1 (EV2) signal is not input to the sub CPU even though the EV1 (EV2) signal is input to the main CPU, the ECM judges that a malfunction has occurred in an internal ECM circuit, and illuminates the MIL and stores a DTC...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Adjustment

ADJUSTMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after completing the rear wheel alignment procedure are shown below. Necessary Procedures After Procedure Performed Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link Rear wheel alignment adjustment ECU Data Initialization Active torque split AWD system Calibration DTCs are stored Slip indicator light illuminates VSC disabled or malfunctions PROCEDURE 1...