Toyota Yaris: Manifold Absolute Pressure Sensor / Installation

Toyota Yaris XP210 (2020-2024) Reapir and Service Manual / Engine & Hybrid System / G16e-gts (engine Control) / Manifold Absolute Pressure Sensor / Installation

INSTALLATION

PROCEDURE

1. INSTALL NO. 2 TURBO PRESSURE SENSOR

(a) Install the No. 2 turbo pressure sensor to the air tube assembly with the 2 bolts.

NOTICE:

If the No. 2 turbo pressure sensor has been struck or dropped, replace it.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

(b) Connect the No. 2 turbo pressure sensor connector.

2. INSTALL NO. 1 TURBO PRESSURE SENSOR

(a) Install the No. 1 turbo pressure sensor to the intake manifold with the bolt.

NOTICE:

If the No. 1 turbo pressure sensor has been struck or dropped, replace it.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

(b) Disconnect the No. 1 turbo pressure sensor connector.

3. CONNECT ENGINE WIRE

(a) Engage the clamp and connect the engine wire.

(b) Install the bolt.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

    Inspection

    INSPECTION PROCEDURE 1. INSPECT NO. 2 TURBO PRESSURE SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition D94-4 (THIM) -D94-2 (E2) - 20°C (- 36°F) 13...

    Mass Air Flow Meter

    ..

    Other information:

    Toyota Yaris XP210 (2020-2024) Reapir and Service Manual: Removal


    REMOVAL CAUTION / NOTICE / HINT HINT: When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used. Learning completes when vehicle is driven Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more...

    Toyota Yaris XP210 (2020-2024) Reapir and Service Manual: Removal


    REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE REAR COMBINATION LIGHT ASSEMBLY (a) Apply protective tape around the rear combination light assembly as shown in the illustration...

    Categories

    Fuel Gauge

    The fuel gauge shows approximately how much fuel is remaining in the tank when the ignition is switched ON. We recommend keeping the tank over 1/4 full.

    Toyota Yaris. Fuel Gauge

    Full 1/4 Full Empty

    read more

     
    Copyright © 2024 www.toyaris4.com