Toyota Yaris: Smart Key System (for Entry Function) / How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
-
Replace parts related to the wireless door lock and smart key system according to the inspection procedure.
-
If the wireless door lock and smart key system does not operate, first check the customize item and make sure that the wireless door lock and smart key system is not turned off.
-
The wireless door lock and smart key system primarily uses the following systems.
-
Power door lock system
-
Wireless door lock system
-
Smart key system (for Entry Function)
-
Smart key system (for Start Function)
-
: Steering lock function
-
: Immobiliser function
-
Perform troubleshooting procedures with other registered keys if available.
PROCEDURE
| 1. | VEHICLE BROUGHT TO WORKSHOP |
(a) Confirm how vehicle was brought to workshop
-
Vehicle was driven
-
Vehicle was towed
HINT:
The malfunction location may be narrowed down by confirming whether the vehicle was driven or towed.
| NEXT |
| GO TO SMART KEY SYSTEM (for Start Function) |
PARTS LOCATION ILLUSTRATION
*1 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY RH *2 FRONT DOOR LOCK WITH MOTOR ASSEMBLY RH *3 BACK DOOR OPENER SWITCH ASSEMBLY *4 OPEN SWITCH *5 LOCK SWITCH *6 BACK DOOR LOCK ASSEMBLY WITH COURTESY LIGHT SWITCH *7 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY LH *8 FRONT DOOR LOCK WITH MOTOR ASSEMBLY LH ILLUSTRATION
*1 FRONT DOOR OUTSIDE HANDLE ASSEMBLY RH - ELECTRICAL KEY ANTENNA - LOCK SENSOR - UNLOCK SENSOR *2 SMART DOOR CONTROL RECEIVER ASSEMBLY *3 ELECTRICAL KEY ANTENNA (OUTSIDE LUGGAGE COMPARTMENT) *4 NO...
Other information:
DESCRIPTION The main body ECU (multiplex network body ECU) and rain sensor communicate via LIN communication. The main body ECU (multiplex network body ECU) stores this DTC if communication becomes abnormal. DTC No. Detection Item DTC Detection Condition Trouble Area Memory DTC Output from B127987 Humidity/Rain Sensor Missing Message
Auxiliary battery voltage is 9...
DISASSEMBLY PROCEDURE 1. REMOVE INPUT SHAFT REAR BEARING SHAFT SNAP RING (a) Using a snap ring expander, remove the input shaft rear bearing shaft snap ring from the input shaft.
2. REMOVE INPUT SHAFT REAR RADIAL BALL BEARING (a) Using SST, remove the input shaft rear radial ball bearing from the input shaft...
Categories
WARNING
When removing the fuel-filler cap, loosen the cap slightly and wait
for
any hissing to stop, then remove it
Fuel spray is dangerous. Fuel can burn skin and eyes and cause illness
if
ingested. Fuel spray is released when there is pressure in the fuel tank and
the fuel-filler cap is removed too quickly.
read more