Toyota Yaris: Axle And Differential / Front Axle Hub

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Drivetrain / Axle And Differential / Front Axle Hub

Differential System

PrecautionPRECAUTION Before disassembly, clean the outside of the differential assembly and remove any sand or mud to prevent it from entering the inside of the assembly during disassembly and installation...

Components

COMPONENTS ILLUSTRATION *1 FRONT AXLE ASSEMBLY *2 FRONT AXLE SHAFT NUT *3 FRONT DISC *4 FRONT DISC BRAKE CALIPER ASSEMBLY *5 FRONT DRIVE SHAFT ASSEMBLY *6 FRONT LOWER NO...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Inspection


INSPECTION PROCEDURE 1. INSPECT HEADLIGHT LEVELING SWITCH (a) Check the voltage. (1) Connect a positive (+) lead from the auxiliary battery to terminal 5 (B) and a negative (-) lead to terminal 2 (E). *a Component without harness connected (Headlight Leveling Switch) (2) Measure the voltage according to the value(s) in the table below...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Intake Air Temperature Sensor 1 Bank 1 Circuit Short to Battery or Open (P011015)


DESCRIPTION Refer to DTC P011011. Click here HINT: When DTC P011015 is stored, the ECM enters fail-safe mode. During fail-safe mode, the intake air temperature is estimated to be 20°C (68°F) by the ECM. Fail-safe mode continues until a pass condition is detected, and the ignition switch is then turned off...

Categories

Refueling

Before refueling, close all the doors, windows, and the liftgate/trunk lid, and switch the ignition OFF.

To open the fuel-filler lid, pull the remote fuel-filler lid release.

Toyota Yaris. Refueling

To remove the fuel-filler cap, turn it counterclockwise. Attach the removed cap to the inner side of the fuel-filler lid.

read more

 
Copyright © 2026 www.toyaris4.com