Toyota Yaris: Lighting Control / Flashing the Headlights
		
		
		
	- OFF
 
	- Flashing
To flash the headlights, pull the 
	lever fully towards you (the headlight switch does not need to be 
	on).
 
The headlight high-beam indicator 
light in the combination meter illuminates simultaneously. The lever 
will return to the normal position 
when released.

   The headlights switch between 
high and low beams by moving 
the lever forward or backward.
When the headlight high-beams 
are on, the headlight high-beam 
indicator light is turned on...
   
 
   The number of passengers and weight of cargo in the luggage compartment 
change the angle of the headlights.
The angle of the headlights will be automatically adjusted when turning on 
the headlights...
   
 
   Other information:
   CALIBRATION POWER STEERING ECU INITIAL SETTING (ASSIST MAP WRITING) (USING GTS) NOTICE: If any of the following conditions are met, perform Power Steering ECU Initial Setting (assist map writing):   
The power steering ECU assembly has been replaced.
 
The electric power steering column sub-assembly has been replaced...
   
   REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the side airbag pressure sensor removal/installation are shown below...
   
 
	 
	
        
		Categories
		
		
The fuel gauge shows approximately how much fuel is remaining in 
the tank when the ignition is switched ON. We recommend keeping 
the tank over 1/4 full.

	Full
	1/4 Full
	Empty
read more