Toyota Yaris: Can Communication System / Data List / Active Test

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Power Source & Network / Networking / Can Communication System / Data List / Active Test

DATA LIST / ACTIVE TEST

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

DATA LIST

(a) Read the Data List.

Body Electrical > Central Gateway > Data List

Tester Display
Total Distance Traveled
Total Distance Traveled - Unit
IG2 SW/IGR SW
IG1 SW/IGP SW
ACC SW
+B Voltage

Body Electrical > Central Gateway > Data List

Tester Display	Measurement Item	Range	Normal Condition
Total Distance Traveled	Total distance traveled	Min.: 0 km (0 mile), Max.: 16777215 km (10425361 mile)	-
Total Distance Traveled - Unit	Total Distance Traveled unit	km or mile	-
IG2 SW/IGR SW	Ignition switch ON signal (IGR terminal)	OFF or ON	OFF: Ignition switch ACC or off ON: Ignition switch ON
IG1 SW/IGP SW	Ignition switch ON signal (IGP terminal)	OFF or ON	OFF: Ignition switch ACC or off ON: Ignition switch ON
ACC SW	Ignition switch ACC signal (ACC terminal)	OFF or ON	OFF: Ignition switch off ON: Ignition switch ACC or ON
+B Voltage	Auxiliary battery voltage (BATT terminal)	Over 8 V or Under 8 V	Over 8 V: Auxiliary battery voltage 8 V or higher Under 8 V: Auxiliary battery voltage below 8 V

Fail-safe Chart

FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) When communication fails in any of the CAN bus lines (communication lines), a fail-safe function(s) will operate...

Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART Diagnostic Trouble Code Chart DTC No. Detection Item Trouble Area Link B102004 Central Gateway ECU System Internal Failure Central gateway ECU (network gateway ECU) U117087 Lost Communication With Brake System Control Module(ch2) Missing Message CAN main/branch bus lines or connector Engine stop and start ECU Brake actuator assembly Central gateway ECU (network gateway ECU) No...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Components

COMPONENTS ILLUSTRATION *1 REAR AXLE HUB AND BEARING ASSEMBLY *2 REAR AXLE SHAFT NUT *3 REAR DISC BRAKE CALIPER ASSEMBLY *4 REAR SPEED SENSOR *5 REAR FLEXIBLE HOSE *6 REAR DRIVE SHAFT ASSEMBLY *7 REAR DISC *8 PARKING BRAKE SHOE ADJUSTING HOLE PLUG Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Cylinder 1 Injector "B" Circuit Open (P21CF13,P21D013,P21D113)

DESCRIPTION The D-4S system has two injection systems. One is an in-cylinder direct injection system that directly injects pressurized fuel into the combustion chamber. The other is an intake port injection system. The ECM determines the percentage of direct injection and port injection necessary in accordance with the engine speed and load...