Toyota Yaris: Clutch / Clutch Pedal

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Drivetrain / Clutch / Clutch Pedal

Installation

INSTALLATION PROCEDURE 1. INSTALL CLUTCH MASTER CYLINDER ASSEMBLY (a) Install a new clutch master cylinder gasket to the clutch master cylinder assembly...

Components

COMPONENTS ILLUSTRATION *1 CLUTCH START SWITCH ASSEMBLY *2 CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN *3 CLUTCH PEDAL SUPPORT ASSEMBLY *4 NO...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Starter Signal Circuit


DESCRIPTION The engine stop and start ECU uses its internal starter circuit to drive the starter drive relay (ST No. 1 relay) and operate the starter. WIRING DIAGRAM CAUTION / NOTICE / HINT When the engine stop and start ECU is replaced, read the number of starter operations before replacement and record this number to the new engine stop and start ECU after replacement...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Diagnostic Trouble Code Chart


DIAGNOSTIC TROUBLE CODE CHART Power Steering System DTC No. Detection Item DTC Detection Condition Warning Indicate Return-to-normal Condition Note Link C05D604 Power Steering Control Module Processor System Internal Failure ECU internal malfunction (CPU malfunction) EPS warning light: Comes on Ignition switch ON again - C05D646 Power Steering Control Module Processor Calibration / Parameter Memory Failure ECU internal malfunction (EEPROM error) EPS warning light: Comes on Ignition switch ON again - C05D649 Power Steering Control Module Processor Internal Electronic Failure ECU internal malfunction (Peripheral circuit malfunction) EPS warning light: Comes on Ignition switch ON again - C10001C Control Module Internal Temperature Sensor "A" Circuit Voltage Out of Range ECU temperature sensor "A" range malfunction EPS warning light: Comes on The ECU judges the system has returned to normal - C123A17 Supply Voltage Circuit Circuit Voltage Above Threshold IG voltage is 18...

Categories

Break-In Period

No special break-in is necessary, but a few precautions in the first 600 miles (1,000 km) may add to the performance, economy, and life of the vehicle.

Do not race the engine. Do not maintain one constant speed, either slow or fast, for a long period of time. Do not drive constantly at full-throttle or high engine rpm for extended periods of time. Avoid unnecessary hard stops. Avoid full-throttle starts.

read more

 
Copyright © 2026 www.toyaris4.com