Toyota Yaris: Clutch Pedal / Components

Toyota Yaris XP210 (2020-2023) Reapir and Service Manual / Drivetrain / Clutch / Clutch Pedal / Components

COMPONENTS

ILLUSTRATION

*1

CLUTCH START SWITCH ASSEMBLY

*2

CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN

*3

CLUTCH PEDAL SUPPORT ASSEMBLY

*4

NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

N*m (kgf*cm, ft.*lbf): Specified torque

Non-reusable part

MP grease

-

-

ILLUSTRATION

*1

TURN OVER CLUTCH PEDAL SPRING

*2

NO. 1 PEDAL SPRING HOOK

*3

CLUTCH PEDAL SPRING HOLDER

*4

CLUTCH PEDAL PAD

    Clutch Pedal

    ..

    On-vehicle Inspection

    ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT CLUTCH PEDAL HEIGHT (a) Remove the front door scuff plate LH. Click here (b) Remove the cowl side trim board LH...

    Other information:

    Toyota Yaris XP210 (2020-2023) Reapir and Service Manual: Lost Communication with Alternator Missing Message (P161A87)


    DESCRIPTION The ECM communicates with the generator assembly via LIN communication. If a LIN communication error is detected, the ECM stores this DTC. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note P161A87 Lost Communication with Alternator Missing Message Generator assembly or ECM communication stops for approximately 17 minutes or more with the ignition switch ON (1 trip detection logic) Wire harness or connector Generator assembly ECM Comes on SAE Code: P161A WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following inspection procedure...

    Toyota Yaris XP210 (2020-2023) Reapir and Service Manual: Fuel Receiver Gauge Malfunction


    DESCRIPTION FUEL RECEIVER GAUGE OPERATION (a) OPERATION The combination meter assembly uses the fuel sender gauge assembly to detect the amount of fuel remaining in the fuel tank assembly. The Hall IC built into the fuel sender gauge assembly changes the output voltage according to the amount of fuel remaining...

    Categories

    Supplemental Restraint System (SRS) Precautions

    The front and side supplemental restraint systems (SRS) include different types of air bags. Please verify the different types of air bags which are equipped on your vehicle by locating the “SRS AIRBAG” location indicators. These indicators are visible in the area where the air bags are installed.

    The air bags are installed in the following locations:

    The steering wheel hub (driver air bag) The front passenger dashboard (front passenger air bag) The outboard sides of the front seatbacks (side air bags) The front and rear window pillars, and the roof edge along both sides (curtain air bags)

    read more

     
    Copyright © 2023 www.toyaris4.com