Toyota Yaris: Window / Glass / Windshield Glass

Window Defogger Wire

On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT DEFOGGER WIRE (BACK DOOR GLASS) NOTICE: When cleaning the glass, wipe the glass along the wire using a soft, dry cloth...

Components

COMPONENTS ILLUSTRATION *1 FRONT DOOR OPENING TRIM WEATHERSTRIP LH *2 FRONT DOOR OPENING TRIM WEATHERSTRIP RH *3 FRONT PILLAR GARNISH LH *4 FRONT PILLAR GARNISH RH *5 FRONT PILLAR GARNISH CLIP - - ● Non-reusable part - - ILLUSTRATION *A w/ Pre-collision System - - *1 VISOR ASSEMBLY LH *2 VISOR ASSEMBLY RH *3 VISOR HOLDER LH *4 VISOR HOLDER RH *5 ASSIST GRIP COVER *6 ASSIST GRIP SUB-ASSEMBLY *7 ROOF HEADLINING *8 FORWARD RECOGNITION WITH HEATER HOOD SUB-ASSEMBLY ILLUSTRATION *1 WINDSHIELD GLASS *2 WINDSHIELD OUTSIDE MOULDING *3 NO...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Installation

INSTALLATION PROCEDURE 1. INSTALL AIR FUEL RATIO SENSOR (a) Using SST, install the air fuel ratio sensor to the front exhaust manifold. SST: 09224-00012 Torque: Specified tightening torque : 44 N·m {449 kgf·cm, 32 ft·lbf} NOTICE: If the air fuel ratio sensor has been struck or dropped, replace it...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Relay

InspectionINSPECTION PROCEDURE 1. INSPECT NO.1 ELECTRONIC FUEL INJECTION MAIN RELAY (EFI-MAIN NO. 1) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 3 - 5 Auxiliary battery voltage not applied between terminals 1 and 2 10 kΩ or higher Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω If the result is not as specified, replace the No...