Toyota Yaris: Tire / Wheel / Tire Repair Seal

NOTICE:

• The valve and valve core cannot be reused.
• Do not reuse items such as cloths that were used to wipe off seal or gloves soiled with the seal. Dispose of such items as burnable waste.

NOTICE:

• Try not to spill the tire repair seal in the tire while performing service.
• Wipe off any spilt seal with a cloth or equivalent.

Inspection

INSPECTION PROCEDURE 1. INSPECT TIRES (a) Inspect the tires for wear and proper inflation pressure. Cold Tire Inflation Pressure: Tire Size Front kPa (kgf/cm2, psi) Rear kPa (kgf/cm2, psi) *1: for driving under 200 km/h (124 mph) *2: for driving at 200 km/h (124 mph) or over 225/40R18 88W 220 (2...

Vehicle Exterior

h..

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Terminals Of Ecu

TERMINALS OF ECU TERMINALS OF ECU *a Component without harness connected (Skid Control ECU [Brake Actuator Assembly]) - - Terminal No. (Symbol) Terminal Description 1 (GND2) Pump motor ground 2 - (Not used) 3 - (Not used) 4 - (Not used) 5 (STP2) Stop light switch assembly input 6 - (Not used) 7 - (Not used) 8 - (Not used) 9 - (Not used) 10 (CANL) CAN communication line L 11 - (Not used) 12 (IGR) ECU power supply input 13 (BM) Motor relay power supply 14 (SP1) Speed signal output for speedometer 15 (RR-) Rear wheel speed RH (-) signal input 16 (RR+) Rear wheel speed RH (+) power supply output 17 (FL-) Front wheel speed LH (-) signal input 18 (FL+) Front wheel speed LH (+) power supply output 19 - (Not used) 20 - (Not used) 21 - (Not used) 22 (CANH) CAN communication line H 23 - (Not used) 24 - (Not used) 25 (GND1) Skid control ECU (brake actuator assembly) ground 26 (STPO) Stop light switch assembly output 27 - (Not used) 28 (RL-) Rear wheel speed LH (-) signal input 29 (RL+) Rear wheel speed LH (+) power supply output 30 (FR-) Front wheel speed RH (-) signal input 31 (FR+) Front wheel speed RH (+) power supply output 32 - (Not used) 33 (CSW) VSC OFF switch (combination switch assembly) input 34 - (Not used) 35 (STP) Stop light switch assembly input 36 (CA2H) CAN communication line H 37 (CA2L) CAN communication line L 38 (+BS) Solenoid relay power supply TERMINAL INSPECTION (a) Disconnect the A108 connector and measure the voltage or resistance on the wire harness side...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: VEHICLE CONTROL HISTORY (RoB)

VEHICLE CONTROL HISTORY (RoB) NOTICE: Replacing or repairing related components may cause vehicle control history codes to be stored. When checking the vehicle control history, make sure to record the output histories. Then, clear the histories and recheck the output histories again...