Toyota Yaris: Back Door Outside Garnish / Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NO. 2 BACK DOOR NAME PLATE
Click here
2. INSTALL NO. 1 BACK DOOR NAME PLATE
Click here
3. INSTALL SYMBOL EMBLEM
Click here
INSTALLATION PROCEDURE 1. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY (a) Engage the clips to install the back door outside garnish sub-assembly as shown in the illustration...
Other information:
INSPECTION PROCEDURE 1. INSPECTION AFTER COLLISION (a) Inspect the SRS parts in table below. CAUTION:
Be sure to read Precaution thoroughly before servicing.
Click here
Be sure to correctly follow the removal and installation procedures for the SRS parts...
DESCRIPTION If the engine stop and start ECU receives the off signal from the certification ECU (smart key ECU assembly) when communication with the ECM is normal, the engine stop and start ECU will output DTC P253014. DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory Note P253014 Ignition Switch Circuit Short to Ground or Open All of the following conditions are met for 10 seconds or more (1 trip detection logic):
Ignition switch off signal is input...
Categories
The front and side supplemental restraint systems (SRS) include different
types of air bags. Please verify the different types of air bags
which are equipped on your vehicle by locating the “SRS AIRBAG”
location indicators. These indicators are visible in the area where the
air bags are installed.
The air bags are installed in the following locations:
The steering wheel hub (driver air bag)
The front passenger dashboard (front passenger air bag)
The outboard sides of the front seatbacks (side air bags)
The front and rear window pillars, and the roof edge along both
sides (curtain air bags)
read more