Toyota Yaris: Back Door Outside Garnish / Disassembly

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Vehicle Exterior / Exterior Panels / Trim / Back Door Outside Garnish / Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE SYMBOL EMBLEM

Click here

2. REMOVE NO. 1 BACK DOOR NAME PLATE

Click here

3. REMOVE NO. 2 BACK DOOR NAME PLATE

Click here

    Removal

    REMOVAL PROCEDURE 1. REMOVE BACK DOOR TRIM BOARD Click here 2. REMOVE BACK DOOR TRIM COVER Click here 3. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY (a) Remove the 4 bolts...

    Reassembly

    R..

    Other information:

    Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Camshaft Position Sensor "A" Bank 1 or Single Sensor No Signal (P034031)


    DESCRIPTION Refer to DTC P034011. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note P034031 Camshaft Position Sensor "A" Bank 1 or Single Sensor No Signal No camshaft position sensor (for intake camshaft) signal for 5 seconds at an engine speed of 600 rpm or higher (1 trip detection logic)...

    Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Stop and Start Cancel Switch Circuit


    DESCRIPTION Stop and start control can be disabled by pressing the stop and start system cancel switch (combination switch assembly). The stop and start system cancel switch (combination switch assembly) is a momentary-type switch that switches between on and off when the switch is pressed...

    Categories

    Break-In Period

    No special break-in is necessary, but a few precautions in the first 600 miles (1,000 km) may add to the performance, economy, and life of the vehicle.

    Do not race the engine. Do not maintain one constant speed, either slow or fast, for a long period of time. Do not drive constantly at full-throttle or high engine rpm for extended periods of time. Avoid unnecessary hard stops. Avoid full-throttle starts.

    read more

     
    Copyright © 2026 www.toyaris4.com