Toyota Yaris: Fuel Pressure Sensor / Installation

Toyota Yaris XP210 (2020-2022) Reapir and Service Manual / Engine & Hybrid System / G16e-gts (fuel) / Fuel Pressure Sensor / Installation

INSTALLATION

CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click here

PROCEDURE

1. INSTALL NO. 2 FUEL PRESSURE SENSOR

HINT:

Perform "Inspection After Repair" after replacing the No. 2 fuel pressure sensor.

Click here

(a) Install a new O-ring to the No. 2 fuel pressure sensor.

(b) Install the No. 2 fuel pressure sensor together with the No. 2 fuel pressure sensor holder to the fuel delivery pipe sub-assembly with the nut.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

(c) Connect the No. 2 fuel pressure sensor connector.

2. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Click here

3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Click here

4. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click here

5. INSPECT FOR FUEL LEAK

Click here

6. PERFORM INITIALIZATION

(a) Perform "Inspection After Repair" after replacing the No. 2 fuel pressure sensor.

Click here

    Inspection

    INSPECTION PROCEDURE 1. INSPECT NO. 2 FUEL PRESSURE SENSOR (a) Check the No. 2 fuel pressure sensor output voltage. (1) Apply 5 V between terminals 1 (VC) and 3 (E2)...

    Fuel Pressure Sensor (for High Pressure)

    ..

    Other information:

    Toyota Yaris XP210 (2020-2022) Reapir and Service Manual: Removal


    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the cover and disc clutch set removal/installation are shown below...

    Toyota Yaris XP210 (2020-2022) Reapir and Service Manual: Reassembly


    REASSEMBLY PROCEDURE 1. INSTALL FRONT BUMPER LOWER ABSORBER (a) Install the 4 grommets. (b) Engage the claws to install the front bumper lower absorber. (c) Install the clip and 5 screws. 2. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY Click here 3...

    Categories

    Refueling

    Before refueling, close all the doors, windows, and the liftgate/trunk lid, and switch the ignition OFF.

    To open the fuel-filler lid, pull the remote fuel-filler lid release.

    Toyota Yaris. Refueling

    To remove the fuel-filler cap, turn it counterclockwise. Attach the removed cap to the inner side of the fuel-filler lid.

    read more

     
    Copyright © 2022 www.toyaris4.com