Toyota Yaris: G16e-gts (fuel) / Fuel Pressure Sensor

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Engine & Hybrid System / G16e-gts (fuel) / Fuel Pressure Sensor

Installation

INSTALLATION PROCEDURE 1. INSTALL FUEL MAIN VALVE ASSEMBLY (a) Apply gasoline to a new O-ring. (b) Install the spacer and O-ring to the fuel main valve assembly...

Components

COMPONENTS ILLUSTRATION *1 NO. 2 FUEL PRESSURE SENSOR *2 NO. 1 ENGINE COVER SUB-ASSEMBLY *3 NO. 2 FUEL PRESSURE SENSOR HOLDER *4 O-RING Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Rear Differential Side Gear Shaft Oil Seal


ComponentsCOMPONENTS ILLUSTRATION *1 REAR DRIVE SHAFT OIL SEAL *2 REAR DIFFERENTIAL FILLER PLUG *3 REAR DIFFERENTIAL DRAIN PLUG *4 REAR DIFFERENTIAL CARRIER ASSEMBLY *5 GASKET - - Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Data List / Active Test


DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. The steering lock ECU (steering lock actuator or upper bracket assembly) communicates with the GTS through the certification ECU (smart key ECU assembly) which uses CAN communication...

Categories

Turning the Engine Off

Stop the vehicle completely. Manual transaxle: Shift into neutral and set the parking brake.

Automatic transaxle: Shift the selector lever to the P position and set the parking brake.

Press the push button start to turn off the engine. The ignition position is off.

read more

 
Copyright © 2026 www.toyaris4.com