Toyota Yaris: Mass Air Flow Meter / Installation

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Engine & Hybrid System / G16e-gts (engine Control) / Mass Air Flow Meter / Installation

INSTALLATION

PROCEDURE

1. INSTALL MASS AIR FLOW METER

(a) Install the mass air flow meter to the air cleaner cap sub-assembly with the 2 screws.

NOTICE:

If the mass air flow meter has been struck or dropped, replace it.
If reusing the mass air flow meter, be sure to inspect the O-ring.
Make sure that the O-ring is not cracked or moved out of place when installing the mass air flow meter.

(b) Connect the mass air flow meter connector.

2. PERFORM INITIALIZATION

(a) Perform "Inspection After Repair" after replacing the mass air flow meter.

Click here

Inspection

INSPECTION PROCEDURE 1. INSPECT MASS AIR FLOW METER (a) Perform a visual check for any foreign matter on the temperature sensor (thermistor) of the mass air flow meter shown in the illustration...

Relay

InspectionINSPECTION PROCEDURE 1. INSPECT NO.1 ELECTRONIC FUEL INJECTION MAIN RELAY (EFI-MAIN NO. 1) (a) Measure the resistance according to the value(s) in the table below...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Customize Parameters

CUSTOMIZE PARAMETERS CUSTOMIZE LTA NOTICE: Record the settings when the vehicle is brought to the workshop so they can be restored. (a) Customizing with the Multi-information Display (1) Turn the ignition switch to ON. (2) Change the setting of the lane tracing assist system by operating the customize switch (steering pad switch)...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Installation

INSTALLATION PROCEDURE 1. INSTALL REAR BUMPER ASSEMBLY (a) Connect the connector. Install in the Direction (b) Engage the claws to install the rear bumper assembly as shown in the illustration. (c) Engage the claws to install the rear bumper assembly as shown in the illustration...