Toyota Yaris: Maintenance / G16e-gts Coolant
INSTALLATION PROCEDURE 1. INSTALL AUXILIARY BATTERY (a) Install the auxiliary battery. (b) Install the battery clamp sub-assembly to the body with the nut and bolt...
COMPONENTS ILLUSTRATION
*1 RESERVE TANK CAP *2 RADIATOR DRAIN COCK PLUG *3 NO. 1 ENGINE UNDER COVER ASSEMBLY - -
N*m (kgf*cm, ft...
Other information:
If the buttons on the smart key are inoperable and the operation indicator
light does not flash, the battery may be dead.
Replace with a new battery before the smart key becomes unusable.
The following conditions indicate that the battery power is low:
The KEY indicator light (green) flashes in the combination meter for
about 30 seconds after the engine is switched OFF...
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT HOOD SUB-ASSEMBLY (a) Check that the clearance measurements of areas "A" through "E" are within each standard range.
Standard Clearance Area Measurement Area Measurement A 2.0 to 6.0 mm (0.0787 to 0...
Categories
The fuel gauge shows approximately how much fuel is remaining in
the tank when the ignition is switched ON. We recommend keeping
the tank over 1/4 full.

Full
1/4 Full
Empty
read more