Toyota Yaris: G16e-gts (fuel) / Fuel Pump (for High Pressure)
INSTALLATION PROCEDURE 1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY (a) Install a new gasket to the fuel tank assembly. (b) Connect the fuel return vent tube sub-assembly to the fuel suction tube with pump and gauge assembly...
COMPONENTS ILLUSTRATION
*1 WATER GUARD PLATE RH *2 NO. 1 FRONT VENTILATOR SEAL *3 OUTER COWL TOP PANEL SUB-ASSEMBLY - -
N*m (kgf*cm, ft...
Other information:
REASSEMBLY PROCEDURE 1. INSTALL FRONT BUMPER LOWER ABSORBER (a) Install the 4 grommets.
(b) Engage the claws to install the front bumper lower absorber.
(c) Install the clip and 5 screws.
2. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY Click here
3...
DESCRIPTION When TRC or VSC is operating, the skid control ECU (brake actuator assembly) blinks the slip indicator light to inform the driver that slippage occurred. When a communication malfunction with the ECM is detected, TRC and VSC are disabled. Also, TRC and VSC are disabled when a DTC is stored...
Categories
The fuel gauge shows approximately how much fuel is remaining in
the tank when the ignition is switched ON. We recommend keeping
the tank over 1/4 full.

Full
1/4 Full
Empty
read more