Toyota Yaris: Front Suspension / Front Suspension Member
INSTALLATION PROCEDURE 1. INSTALL FRONT STABILIZER BAR (a) Set the front stabilizer bar to the front suspension crossmember sub-assembly. NOTICE: Make sure that the identification mark is positioned on the right side of the vehicle...
COMPONENTS ILLUSTRATION
*1 NO. 1 ENGINE UNDER COVER ASSEMBLY *2 CENTER NO. 4 ENGINE UNDER COVER *3 ENGINE UNDER COVER LH *4 ENGINE UNDER COVER RH
N*m (kgf*cm, ft...
Other information:
DESCRIPTION If a door glass does not slide smoothly or a power window regulator motor assembly or door window regulator sub-assembly does not operate smoothly, the jam protection function may be triggered automatically, resulting in the auto up operation being unable to fully close the power window...
REMOVAL PROCEDURE 1. DISCONNECT ENGINE WIRE (a) Remove the bolt.
(b) Disengage the clamp and disconnect the engine wire. 2. REMOVE NO. 1 TURBO PRESSURE SENSOR (a) Disconnect the No. 1 turbo pressure sensor connector.
(b) Remove the bolt and No...
Categories
WARNING
When removing the fuel-filler cap, loosen the cap slightly and wait
for
any hissing to stop, then remove it
Fuel spray is dangerous. Fuel can burn skin and eyes and cause illness
if
ingested. Fuel spray is released when there is pressure in the fuel tank and
the fuel-filler cap is removed too quickly.
read more