Toyota Yaris: Headup Display System / Dtc Check / Clear

Terminals Of Ecu

TERMINALS OF ECU METER MIRROR SUB-ASSEMBLY (a) Measure the voltage and resistance according to the value(s) in the table below. Terminal No. (Symbol) Terminal Description Condition Specified Condition H61-1 (IG) - Body ground Power source for engine stop and start ECU assembly Ignition switch off Below 1 V Ignition switch ON 10...

Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not...

Other information:

Toyota Yaris XP210 (2020-2025) Reapir and Service Manual: Lost Communication with ECM/PCM "A" Missing Message (U010087,U012687,U012987,U013187,U014087,U015187,U015587,U016487,U117087)

DESCRIPTION The engine stop and start ECU communicates with the SFI system, electronically controlled brake system, power steering system, air conditioning system, airbag system and main body ECU (multiplex network body ECU) via CAN communication. If there is a communication error between the engine stop and start ECU and any of the systems, the engine stop and start ECU stores DTCs and illuminates the stop and start cancel indicator except when there is a communication error with the meter / gauge system...

Toyota Yaris XP210 (2020-2025) Owner's Manual: Removal/Installation

To remove the head restraint, pull it up while pressing the stop-catch. To install the head restraint, insert the legs into the holes while pressing the stop-catch. WARNING Always drive with the head restraints installed when seats are being used and make sure they are properly installed Driving with the head restraints not installed is dangerous...