Toyota Yaris: Headup Display System / Terminals Of Ecu

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Vehicle Interior / Meter / Gauge / Display / Headup Display System / Terminals Of Ecu

TERMINALS OF ECU

METER MIRROR SUB-ASSEMBLY

(a) Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol)	Terminal Description	Condition	Specified Condition
H61-1 (IG) - Body ground	Power source for engine stop and start ECU assembly	Ignition switch off	Below 1 V
H61-1 (IG) - Body ground	Power source for engine stop and start ECU assembly	Ignition switch ON	10.5 to 16 V
H61-2 (B) - Body ground	Power source for engine stop and start ECU assembly	Ignition switch off	11 to 14 V
H61-4 (ES) - Body ground	Ground	Always	Below 1 Ω
H61-12 (MPX1)	CAN communication line	-	-
H61-13 (MPX2)	CAN communication line	-	-
H61-14 (TX+)	Local bus communication line	-	-
H61-15 (TX-)	Local bus communication line	-	-

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE NOTICE: When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored...

Dtc Check / Clear

D..

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Front Left Air Mix Damper Control Servo Motor Actuator Stuck Off (B144C7F)

DESCRIPTION The No. 1 air conditioning radiator damper servo sub-assembly sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on these signals to move the air outlet damper to the appropriate position, which controls the air outlet switching...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Engine Coolant Temperature Sensor 1 Circuit Short to Battery or Open (P011515)

DESCRIPTION Refer to DTC P011511. Click here HINT: When DTC P011515 is stored, the ECM enters fail-safe mode. During fail-safe mode, the ECM sets the engine coolant temperature judgment value to 80°C (176°F) and the target engine coolant temperature to 82°C (180°F)...