Toyota Yaris: Can Communication System / Dtc Check / Clear

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Power Source & Network / Networking / Can Communication System / Dtc Check / Clear

DTC CHECK / CLEAR

CHECK FOR DTC

(a) Read the DTCs.

Body Electrical > Central Gateway > Trouble Codes

CLEAR DTC

(a) Read the DTCs.

Body Electrical > Central Gateway > Trouble Codes

(b) Clear the DTCs.

Body Electrical > Central Gateway > Clear DTCs

Diagnosis System

DIAGNOSIS SYSTEM NOTICE: The following communication bus check screen is provided only as an example. This screen differs from the actual screen for this vehicle...

Fail-safe Chart

FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) When communication fails in any of the CAN bus lines (communication lines), a fail-safe function(s) will operate...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT RAIN SENSOR (a) Remove the rain sensor cover. Click here (b) Disconnect the rain sensor connector. (c) Measure the voltage according to the value(s) in the table below. Standard Voltage: Tester Connection Condition Specified Condition V9-4 (SIG) - V9-2 (ES) Ignition switch ON 11 to 14 V If the result is not as specified, repair or replace the harness or connector...

Toyota Yaris XP210 (2020-2026) Owner's Manual: Laser Sensor

The Low Speed Pre-Collision System laser sensor is installed at the top of the windshield near the rearview mirror. Always keep the surface of the windshield around the laser sensor clean to assure proper operation of the Low Speed PreCollision System...