Toyota Yaris: Rear Console Box / Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE PARKING BRAKE HOLE COVER SUB-ASSEMBLY
(a) Disengage the claws to remove the parking brake hole cover sub-assembly. | |
REMOVAL PROCEDURE 1. REMOVE CENTER LOWER INSTRUMENT COVER (a) Apply protective tape to the locations shown in the illustration.
Protective Tape (b) Using a screwdriver with its tip wrapped in protective tape, disengage the clip and guide to remove the center lower instrument cover as shown in the illustration...
Other information:
DESCRIPTION Refer to DTC P10D311. Click here
DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note P10D315 Charge Air Cooler Temperature Sensor 2 Bank 1 Circuit Short to Battery or Open The output voltage from the intake air temperature sensor is higher than 4...
INITIALIZATION INITIALIZE POWER WINDOW CONTROL SYSTEM (ALL DOORS) NOTICE:
When a power window regulator motor assembly, door window regulator sub-assembly, door belt moulding or door glass weatherstrip inner have been removed and installed, or if a power window regulator motor assembly was reused when a door glass or door glass run was replaced, the power window control system must be initialized...
Categories
Before refueling, close all the doors, windows, and the liftgate/trunk
lid, and switch the ignition OFF.
To open the fuel-filler lid, pull
the remote fuel-filler lid release.

To remove the fuel-filler cap, turn it counterclockwise.
Attach the removed cap to the
inner side of the fuel-filler lid.
read more