Toyota Yaris: Hood / Components
COMPONENTS
ILLUSTRATION
| *1 | HOOD INSULATOR | *2 | HOOD STAY HOLDER |
| *3 | HOOD SUPPORT ASSEMBLY | *4 | HOOD BUMPER CUSHION |
| ● | Non-reusable part | - | - |
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT HOOD SUB-ASSEMBLY (a) Check that the clearance measurements of areas "A" through "E" are within each standard range...
Other information:
INSPECTION PROCEDURE 1. INSPECT REAR SEAT INNER BELT ASSEMBLY LH (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition
If the result is not as specified, replace the rear seat inner belt assembly LH...
COMPONENTS ILLUSTRATION
*1 CENTER LOWER INSTRUMENT COVER *2 SWITCH HOLE BASE SUB-ASSEMBLY *3 SHIFT LEVER KNOB SUB-ASSEMBLY *4 LOWER INSTRUMENT PANEL FINISH PANEL *5 FRONT DOOR SCUFF PLATE LH *6 COWL SIDE TRIM BOARD LH *7 FRONT DOOR OPENING TRIM WEATHERSTRIP LH *8 NO...
Categories
If a key is left in the vehicle, the functions of the key left in the vehicle
are temporarily suspended to prevent theft of the vehicle.
To restore the functions, press the unlock button on the functions-suspended
key in the vehicle.
read more