Toyota Yaris: Clutch / Clutch Stroke Sensor
ComponentsCOMPONENTS ILLUSTRATION
*1 CLUTCH START SWITCH ASSEMBLY *2 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY *3 CLUTCH PEDAL SUPPORT ASSEMBLY - -
N*m (kgf*cm, ft...
COMPONENTS ILLUSTRATION
*1 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY *2 CLUTCH PEDAL STROKE SENSOR ASSEMBLY *3 BRAKE PEDAL RETURN SPRING - -
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft...
Other information:
DESCRIPTION The power steering ECU assembly supplies a voltage of 5 V to the torque sensor (electric power steering column sub-assembly) and monitors the voltage value of the Hall IC inside the torque sensor (electric power steering column sub-assembly) which changes in response to changes in the magnetic flux density (steering torque) detected by the Hall IC, and calculates the assist torque...
DESCRIPTION
This is the troubleshooting procedure for situations where the engine does not restart after having been stopped by the stop and start system.
For information on stop and start control, refer to the system description.
Click here
CAUTION / NOTICE / HINT PRECAUTIONS WHEN THE ENGINE STOP AND START ECU AND THE STARTER ASSEMBLY ARE REPLACED NOTICE:
When the engine stop and start ECU is replaced, it is necessary to read the number of starter operations before replacement and store this number in the new engine stop and start ECU after replacement, and to perform external backup boost converter (eco run vehicle converter assembly) existence learning...
Categories
Before refueling, close all the doors, windows, and the liftgate/trunk
lid, and switch the ignition OFF.
To open the fuel-filler lid, pull
the remote fuel-filler lid release.

To remove the fuel-filler cap, turn it counterclockwise.
Attach the removed cap to the
inner side of the fuel-filler lid.
read more