Toyota Yaris: Clutch / Clutch Master Cylinder

Toyota Yaris XP210 (2020-2023) Reapir and Service Manual / Drivetrain / Clutch / Clutch Master Cylinder

Clutch

..

Components

COMPONENTS ILLUSTRATION *1 CLUTCH MASTER CYLINDER GASKET *2 CLUTCH MASTER CYLINDER ASSEMBLY *3 CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN *4 CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE *5 NO...

Other information:

Toyota Yaris XP210 (2020-2023) Reapir and Service Manual: Inspection


INSPECTION PROCEDURE 1. INSPECT STEERING WHEEL SWITCH HOUSING (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. *a Component without harness connected (Steering Wheel Switch Housing) - - Standard Resistance: Light Switch Circuit Tester Connection Condition Specified Condition z6-3 (T) - z4-3 (T) Always Below 1 Ω z6-12 (H) - z4-4 (H) Always Below 1 Ω z6-7 (A) - z4-5 (A) Always Below 1 Ω z6-16 (HU) - z4-6 (HU) Always Below 1 Ω z6-11 (HF) - z4-7 (HF) Always Below 1 Ω z6-8 (TR) - z4-8 (TR) Always Below 1 Ω z6-14 (TL) - z4-9 (TL) Always Below 1 Ω z6-6 (CR) - z4-10 (CR) Always Below 1 Ω z6-13 (BFG) - z4-11 (BFG) Always Below 1 Ω z6-4 (B) - z4-12 (B) Always Below 1 Ω z6-5 (EL) - z4-13 (EL) Always Below 1 Ω Wiper Switch Circuit Tester Connection Condition Specified Condition z5-10 (W_OFF) - z4-24 (W_OFF) Always Below 1 Ω z5-13 (+S) - z4-25 (+S) Always Below 1 Ω z5-11 (+1) - z4-26 (+1) Always Below 1 Ω z5-12 (+2) - z4-27 (+2) Always Below 1 Ω z5-14 (MIST) - z4-28 (MIST) Always Below 1 Ω z5-15 (WF) - z4-31 (WF) Always Below 1 Ω z5-5 (E) - z4-33 (E) Always Below 1 Ω z5-4 (VR) - z4-34 (VR) Always Below 1 Ω If the result is not as specified, replace the steering wheel switch housing...

Toyota Yaris XP210 (2020-2023) Reapir and Service Manual: Camshaft Position Sensor "A" Bank 1 or Single Sensor No Signal (sub) (P034000)


DESCRIPTION Refer to DTC P034011. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note P034000 Camshaft Position Sensor "A" Bank 1 or Single Sensor No Signal (sub) No camshaft position sensor (for intake camshaft) signal to the sub ECM while engine running ECM Comes on SAE: P0340 MONITOR DESCRIPTION While the engine is running, when the VV1 (VV2) signal is not input to the sub CPU even though the VV1 (VV2) signal is input to the main CPU, the ECM judges that a malfunction has occurred in an internal ECM circuit, and illuminates the MIL and stores a DTC...

Categories

Refueling

Before refueling, close all the doors, windows, and the liftgate/trunk lid, and switch the ignition OFF.

To open the fuel-filler lid, pull the remote fuel-filler lid release.

Toyota Yaris. Refueling

To remove the fuel-filler cap, turn it counterclockwise. Attach the removed cap to the inner side of the fuel-filler lid.

read more

 
Copyright © 2023 www.toyaris4.com