Toyota Yaris: G16e-gts (emission Control) / Canister
COMPONENTS ILLUSTRATION
*1 FUEL PUMP *2 FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY *3 FUEL SENDER GAUGE ASSEMBLY *4 CANISTER (FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY) *5 FUEL MAIN VALVE ASSEMBLY *6 NO...
Other information:
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR (a) Check the wire harness. (1) Disconnect the automatic light control sensor. (2) Measure the voltage according to the value(s) in the table below. Standard Voltage: Tester Connection Switch Condition Specified Condition H78-1 (CLTB) - H78-2 (CLTE) Ignition switch on (IG) 11 to 14 V If the specified condition is not met, replace the vehicle wire harness...
INSTALLATION PROCEDURE 1. INSTALL MASS AIR FLOW METER (a) Install the mass air flow meter to the air cleaner cap sub-assembly with the 2 screws. NOTICE:
If the mass air flow meter has been struck or dropped, replace it.
If reusing the mass air flow meter, be sure to inspect the O-ring...
Categories
WARNING
Never allow a person to ride in the luggage compartment/trunk
Allowing a person to ride in the luggage compartment/trunk is
dangerous.
The person in the luggage compartment/trunk could be seriously injured or
killed during sudden braking or a collision.
Do not drive with the liftgate/trunk lid open
read more