Toyota Yaris: G16e-gts (engine Control) / Camshaft Oil Control Solenoid

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Engine & Hybrid System / G16e-gts (engine Control) / Camshaft Oil Control Solenoid

Installation

INSTALLATION PROCEDURE 1. INSTALL NO. 2 AIR FUEL RATIO SENSOR (a) Using SST, install the No. 2 air fuel ratio sensor to the front exhaust pipe assembly...

Components

COMPONENTS ILLUSTRATION *A for Intake Side *B for Exhaust Side *1 CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY *2 O-RING N*m (kgf*cm, ft...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Parts Location


PARTS LOCATION ILLUSTRATION *1 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY RH *2 FRONT DOOR LOCK WITH MOTOR ASSEMBLY RH *3 BACK DOOR OPENER SWITCH ASSEMBLY *4 OPEN SWITCH *5 LOCK SWITCH *6 BACK DOOR LOCK ASSEMBLY WITH COURTESY LIGHT SWITCH *7 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY LH *8 FRONT DOOR LOCK WITH MOTOR ASSEMBLY LH ILLUSTRATION *1 FRONT DOOR OUTSIDE HANDLE ASSEMBLY RH - ELECTRICAL KEY ANTENNA - LOCK SENSOR - UNLOCK SENSOR *2 SMART DOOR CONTROL RECEIVER ASSEMBLY *3 ELECTRICAL KEY ANTENNA (OUTSIDE LUGGAGE COMPARTMENT) *4 NO...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Actuator Cut Circuit Stuck Off (P16B09F)


MONITOR DESCRIPTION The ECM monitors the operation of the throttle actuator. When a malfunction is detected in the throttle actuator cut circuit immediately after the ignition switch is turned off, the ECM illuminates the MIL and stores a DTC. DTC No...

Categories

Turning the Engine Off

Stop the vehicle completely. Manual transaxle: Shift into neutral and set the parking brake.

Automatic transaxle: Shift the selector lever to the P position and set the parking brake.

Press the push button start to turn off the engine. The ignition position is off.

read more

 
Copyright © 2026 www.toyaris4.com