Toyota Yaris: Climate Control System / Vent Operation

Operating Tips

Operate the climate control system with the engine running. To prevent the battery from being discharged, do not leave the fan control dial on for a long period of time with the ignition switched ON when the engine is not running...

Adjusting the Vents

Air vent open/close The air vents can be fully opened and closed by operating the knob. Center vents (driver) and Side vents Open Close Center vents (front passenger) Open Close Directing airflow To adjust the direction of airflow, move the adjustment knob...

Other information:

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Parts Location

PARTS LOCATION ILLUSTRATION *A w/ Toyota Safety Sense *B w/ Active Noise Control System *1 ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY) *2 VACUUM SENSOR ASSEMBLY *3 INNER REAR VIEW MIRROR ASSEMBLY *4 ECM *5 SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) *6 EXTERNAL BACKUP BOOST CONVERTER (ECO RUN VEHICLE CONVERTER ASSEMBLY) *7 MILLIMETER WAVE RADAR SENSOR ASSEMBLY *8 FORWARD RECOGNITION CAMERA *9 ENGINE ROOM RELAY BLOCK - EFI-MAIN NO...

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: 4WD/AWD Range Actuator Temperature Sensor Circuit Range/Performance Circuit Voltage Out of Range (C11411C)

DESCRIPTION When a malfunction has occurred in the AWD coupling solenoid system, the AWD ECU assembly stores DTC C11411C. DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory C11411C 4WD/AWD Range Actuator Temperature Sensor Circuit Range/Performance Circuit Voltage Out of Range Even though it can be inferred from the driving conditions that the coupling is generating a significant amount of heat, the temperature sensor value is approximately -10°C (14°F) for 1 second or more, and this continues despite the ignition switch being turned off and then ON again 2 times Even though the engine coolant temperature received from the ECM is less than 35°C (95°F), the temperature sensor value is fixed at 155°C (311°F) (short circuit condition), and this continues despite the ignition switch being turned off and then ON again 2 times The temperature sensor power source voltage is 0...