Toyota Yaris: Bluetooth® Hands-Free / Receiving an Incoming Call
When an incoming call is received, the incoming call notification
screen is displayed. The “Incoming Call Notifications” setting must be
on. Refer to Communication Settings.
To accept the call, press the pick-up button on the audio control switch
or select
on the screen.
To reject the call, press the hang-up button on the audio control switch
or select
on the screen.
The following icons are displayed on the screen during a call. Icons
which can be used differ depending on use conditions.


- If the ignition is switched off during a hands-free call, the line is
transferred
to the device (Mobile phone) automatically.
- If the DTMF code has two or more digits or symbols, each one must be
transmitted individually.
Phonebook Usage
Telephone calls can be made by saying the contact name in the
downloaded phonebook or the name of a person whose phone
number has been registered in the Bluetooth® Hands-Free...
A call can be interrupted to receive an incoming call from a third party.
When is selected or the pick-up
button on the steering
wheel is pressed, the current call is held and the system switches to
the new incoming call...
Other information:
TERMINALS OF ECU CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
(a) Disconnect the H45 and H46 certification ECU (smart key ECU assembly) connectors. (b) Measure the resistance and voltage according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconnected...
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear axle carrier sub-assembly removal/ installation are shown below...
Categories
Stop the vehicle completely.
Manual transaxle:
Shift into neutral and set the parking brake.
Automatic transaxle:
Shift the selector lever to the P position and set the parking brake.
Press the push button start to turn off the engine. The ignition position is
off.
read more