Toyota Yaris: Axle And Differential / Rear Axle Carrier
ComponentsCOMPONENTS ILLUSTRATION
*1 FRONT AXLE HUB BOLT *2 FRONT DISC *3 FRONT DISC BRAKE CALIPER ASSEMBLY - -
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft...
COMPONENTS ILLUSTRATION
*1 REAR AXLE HUB AND BEARING ASSEMBLY *2 REAR AXLE SHAFT NUT *3 REAR DISC BRAKE CALIPER ASSEMBLY *4 REAR SPEED SENSOR *5 REAR FLEXIBLE HOSE *6 REAR DRIVE SHAFT ASSEMBLY *7 REAR BRAKE *8 REAR DISC *9 PARKING BRAKE SHOE ADJUSTING HOLE PLUG - -
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft...
Other information:
Parts LocationPARTS LOCATION ILLUSTRATION
*1 LOW PITCHED HORN ASSEMBLY *2 NO. 1 ENGINE ROOM RELAY BLOCK AND NO. 1 JUNCTION BLOCK ASSEMBLY - HORN RELAY - HORN FUSE ILLUSTRATION
*1 HORN BUTTON ASSEMBLY *2 SPIRAL CABLE SUB-ASSEMBLY *3 MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) *4 POWER DISTRIBUTION BOX ASSEMBLY *5 DLC3 - - System DiagramSYSTEM DIAGRAM
Problem Symptoms TablePROBLEM SYMPTOMS TABLE NOTICE: If the main body ECU (multiplex network body ECU) is replaced, refer to the Registration...
DESCRIPTION These DTCs are stored when there is a CAN communication malfunction between the certification ECU (smart key ECU assembly) and ECM, main body ECU (multiplex network body ECU) or combination meter assembly. DTC No. Detection Item DTC Detection Condition Trouble Area Note U010087 Lost Communication with ECM/PCM "A" Missing Message CAN communication malfunction between certification ECU (smart key ECU assembly) and ECM (1-trip detection logic*) ECM
Turn the ignition switch to ON and wait at least 10 seconds...
Categories
Stop the vehicle completely.
Manual transaxle:
Shift into neutral and set the parking brake.
Automatic transaxle:
Shift the selector lever to the P position and set the parking brake.
Press the push button start to turn off the engine. The ignition position is
off.
read more