Toyota Yaris: Window / Glass / Quarter Window Glass
INSTALLATION PROCEDURE 1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY (a) Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly...
Other information:
INSPECTION PROCEDURE 1. INSPECT AUTO HIGH BEAM SWITCH (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition H47-5 (+B) - H47-2 (E) Auto high beam switch off 10 kΩ or higher H47-5 (+B) - H47-2 (E) Auto high beam switch on Below 1 Ω If the result is not as specified, replace the auto high beam switch...
PARTS LOCATION ILLUSTRATION
*1 OUTER REAR VIEW MIRROR ASSEMBLY LH - OUTER MIRROR LH *2 OUTER REAR VIEW MIRROR ASSEMBLY RH - OUTER MIRROR RH *3 OUTER MIRROR SWITCH ASSEMBLY *4 NO. 1 ENGINE ROOM RELAY BLOCK AND NO. 1 JUNCTION BLOCK ASSEMBLY - ECU-IGP NO...
Categories
WARNING
Never allow a person to ride in the luggage compartment/trunk
Allowing a person to ride in the luggage compartment/trunk is
dangerous.
The person in the luggage compartment/trunk could be seriously injured or
killed during sudden braking or a collision.
Do not drive with the liftgate/trunk lid open
read more