Toyota Yaris: Power Window Regulator Motor / Installation

Toyota Yaris XP210 (2020-2023) Reapir and Service Manual / Vehicle Exterior / Window / Glass / Power Window Regulator Motor / Installation

INSTALLATION

PROCEDURE

1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly.

(b) Install the power window regulator motor assembly with the 3 bolts.

Torque:

5.4 N·m {55 kgf·cm, 48 in·lbf}

HINT:

When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

2. INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY

Click here

3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

Click here

4. INSTALL WINDOW REGULATOR SHIM

Click here

5. INSPECT FRONT DOOR GLASS SUB-ASSEMBLY

Click here

6. ADJUST FRONT DOOR GLASS SUB-ASSEMBLY

Click here

7. INSTALL HOLE PLUG

Click here

8. INSTALL FRONT DOOR SERVICE HOLE COVER

Click here

9. INSTALL FRONT DOOR GLASS INNER WEATHERSTRIP

Click here

10. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Click here

11. INSTALL FRONT DOOR TRIM GARNISH

Click here

12. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side)

Click here

13. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)

Click here

14. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

Click here

15. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Click here

16. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click here

17. INITIALIZE POWER WINDOW CONTROL SYSTEM

Click here

18. INSPECT POWER WINDOW OPERATION

Click here

    Inspection

    INSPECTION CAUTION / NOTICE / HINT NOTICE: Do not apply positive (+) auxiliary battery voltage to any terminals, except terminal K7-2 (B) or L7-2 (B), to avoid damaging the pulse sensor inside the motor...

    Quarter Window Glass

    ..

    Other information:

    Toyota Yaris XP210 (2020-2023) Reapir and Service Manual: Crankshaft Position Sensor "A" No Signal (P033531)


    DESCRIPTION This DTC is output when a malfunction has occurred in the engine pulse signal system from the ECM. DTC No. Detection Item DTC Detection Condition Trouble Area P033531 Crankshaft Position Sensor "A" No Signal Stereo component equalizer assembly detects malfunction in engine pulse signal system for 10 seconds or more continuously when engine speed is between 500 and 6000 rpm* Harness or connector ECM Stereo component equalizer assembly HINT: *: Malfunction monitoring is not performed under the following conditions, in order to prevent erroneous detection...

    Toyota Yaris XP210 (2020-2023) Reapir and Service Manual: Operation Check


    OPERATION CHECK CHECK FRONT WIPER CONTROL (a) Auto wiper function (1) Continuously apply water to the windshield glass in front of the rain sensor. (2) Turn the ignition switch to ON. (3) Move the front wiper switch to the AUTO position. (4) Check that the front wipers operate...

    Categories

    Keys

    Toyota Yaris. Keys

    Smart key Auxiliary key Key code number plate

    To use the auxiliary key, press the knob and pull out the auxiliary key from the smart key.

    Toyota Yaris. Keys

    read more

     
    Copyright © 2023 www.toyaris4.com