Toyota Yaris: Manual Transaxle System / Precaution

Toyota Yaris XP210 (2020-2023) Reapir and Service Manual / Drivetrain / Ea67f (manual Transmission / Transaxle) / Manual Transaxle System / Precaution




  • The iMT system may not detect the gear change performed by the driver when a certain amount of time elapses between the clutch operation and shift operation or when the shift lever is operated while coasting with the shift lever in N.
  • After the iMT system adjusts the engine speed and a certain amount of time elapses, the operation completes. Even during this time, the iMT system operates again if it detects a clutch pedal reengagement and a gear change operation.
  • The iMT system may not operate if the clutch pedal is not completely released and fully depressed.
  • When the clutch is quickly engaged, the speed synchronization operation by the iMT system may not occur in time.
  • When there is a malfunction in the engine system or ABS system, the iMT system may stop operating.

    Manual Transaxle System


    Parts Location


    Other information:

    Toyota Yaris XP210 (2020-2023) Reapir and Service Manual: Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during forward recognition camera removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced Replacement Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link Forward recognition camera Adjust forward recognition camera Dynamic Radar Cruise Control System Front Camera System Lane Tracing Assist System Pre-collision System Automatic High Beam System One Time Recognition: Sequential Recognition: Driving Adjustment: Update ECU security key Vehicle control history (RoB) are stored NOTICE: When replacing the forward recognition camera, replace it with a new one...

    Toyota Yaris XP210 (2020-2023) Reapir and Service Manual: Driver Side Door Entry Lock and Unlock Functions do not Operate

    DESCRIPTION If the entry lock and unlock functions do not operate for the driver door only, the request code may not be being transmitted from the driver door or the front door outside handle assembly LH (touch sensor) may be malfunctioning. If the entry functions for other doors operate properly, communication between the electrical key transmitter sub-assembly and the smart door control receiver assembly is normal...


    Liftgate/Trunk Lid


    Never allow a person to ride in the luggage compartment/trunk

    Allowing a person to ride in the luggage compartment/trunk is dangerous. The person in the luggage compartment/trunk could be seriously injured or killed during sudden braking or a collision.

    Do not drive with the liftgate/trunk lid open

    read more

    Copyright © 2023