Toyota Yaris: Cylinder Block / Precaution
PRECAUTION
HINT:
-
Any digits beyond the 0.01 mm (1/1000 in.) place for standard, minimum and maximum values should be used as a reference only.
-
When both standard and maximum or minimum values are listed for an inspection, use the standard value as a reference only and base any judgments on the maximum and minimum values.
COMPONENTS ILLUSTRATION
*1 RING PIN *2 STRAIGHT PIN *3 STUD BOLT *4 NO. 3 OIL NOZZLE SUB-ASSEMBLY *5 NO. 2 OIL NOZZLE SUB-ASSEMBLY *6 NO...
Other information:
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WIPER RELAY (a) Check the operation of the windshield wiper relay. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 3 - 5 Auxiliary battery voltage not applied between terminals 1 and 2 10 kΩ or higher Auxiliary battery voltage applied between terminals 1 and 2 Below 1 Ω If the result is not as specified, replace the windshield wiper relay...
DISASSEMBLY PROCEDURE 1. REMOVE LOWER DEFROSTER NOZZLE ASSEMBLY (a) Disengage the claws and guides to remove the lower defroster nozzle assembly.
2. REMOVE COOLER PIPE GROMMET (a) Remove the cooler pipe grommet.
3. REMOVE COOLER EXPANSION VALVE (a) Using a 4 mm hexagon socket wrench, remove the 2 hexagon bolts and cooler expansion valve...
Categories
The fuel gauge shows approximately how much fuel is remaining in
the tank when the ignition is switched ON. We recommend keeping
the tank over 1/4 full.

Full
1/4 Full
Empty
read more