Toyota Yaris: Pre-collision System / Parts Location

Toyota Yaris XP210 (2020-2026) Reapir and Service Manual / Vehicle Interior / Pre-collision / Pre-collision System / Parts Location

PARTS LOCATION

ILLUSTRATION

*1

FORWARD RECOGNITION CAMERA

*2

MILLIMETER WAVE RADAR SENSOR ASSEMBLY

*3

BRAKE ACTUATOR ASSEMBLY

- SKID CONTROL ECU

*4

ECM

ILLUSTRATION

*1

COMBINATION METER ASSEMBLY

- MULTI-INFORMATION DISPLAY

- PCS WARNING LIGHT

*2

STEERING SENSOR

*3

POWER DISTRIBUTION BOX ASSEMBLY

- ECU-IGR NO. 2 FUSE

*4

DLC3

    Precaution

    PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE: When disconnecting the cable from the negative (-) auxiliary battery terminal, some systems must be initialized after the cable is reconnected...

    System Diagram

    S..

    Other information:

    Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Front Right Microphone Circuit Component Internal Failure (B1AA696,B1AA71C)


    DESCRIPTION These DTCs are stored when a malfunction occurs in the active noise control microphone RH system. DTC No. Detection Item DTC Detection Condition Trouble Area B1AA696 Front Right Microphone Circuit Component Internal Failure Stereo component equalizer assembly detects malfunction in active noise control microphone RH for 4 seconds or more continuously when engine speed is 1200 rpm or more* Harness or connector Active noise control microphone RH Stereo component equalizer assembly B1AA71C Front Right Microphone Circuit Circuit Voltage Out of Range Stereo component equalizer assembly detects active noise control microphone RH connection malfunction for 4 seconds or more continuously* Harness or connector Active noise control microphone RH Stereo component equalizer assembly HINT: *: Malfunction monitoring is not performed under the following conditions, in order to prevent erroneous detection...

    Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Reassembly


    REASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. INSTALL STOP LIGHT LED (a) Install the stop light LED as shown in the illustration to install it...

    Categories

    Supplemental Restraint System (SRS) Precautions

    The front and side supplemental restraint systems (SRS) include different types of air bags. Please verify the different types of air bags which are equipped on your vehicle by locating the “SRS AIRBAG” location indicators. These indicators are visible in the area where the air bags are installed.

    The air bags are installed in the following locations:

    The steering wheel hub (driver air bag) The front passenger dashboard (front passenger air bag) The outboard sides of the front seatbacks (side air bags) The front and rear window pillars, and the roof edge along both sides (curtain air bags)

    read more

     
    Copyright © 2026 www.toyaris4.com