Toyota Yaris: Door Locks / Locking, Unlocking with Door-Lock Knob

Toyota Yaris XP210 (2020-2026) Owner's Manual / Before Driving / Door and Locks / Door Locks / Locking, Unlocking with Door-Lock Knob

Operation from inside

Toyota Yaris. Locking, Unlocking with Door-Lock Knob

  1. Lock

    To lock any door from the inside, press the door-lock knob.

  2. Unlock

    To unlock, pull it outward.

This does not operate the other door locks.

Operation from outside

Toyota Yaris. Locking, Unlocking with Door-Lock Knob

To lock any door using its door-lock knob from the outside, press the door-lock knob to the lock position and close the door (holding the door handle in the open position is not required).

This does not operate the other door locks.

When locking the door this way:

  • Be careful not to leave the key inside the vehicle.
  • The doors cannot be locked using the driver’s door lock knob if any door is open when the ignition is switched to ACC or ON.

The red indication can be seen when the door-lock knob is unlocked.

Toyota Yaris. Locking, Unlocking with Door-Lock Knob

    Auto Lock/Unlock Function

     When the vehicle speed exceeds 12 mph (20 km/h), all doors and the liftgate lock automatically. When the ignition is switched off, all doors and the liftgate unlock automatically...

    Rear Door Child Safety Locks

    These locks are intended to help prevent children from accidentally opening the rear doors. Use them on both rear doors whenever a child rides in the rear seat of the vehicle...

    Other information:

    Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Components


    COMPONENTS ILLUSTRATION *1 NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY *2 VALVE LASH ADJUSTER ASSEMBLY *3 VALVE STEM CAP *4 CYLINDER HEAD SUB-ASSEMBLY *5 CYLINDER HEAD GASKET *6 CYLINDER HEAD SET BOLT *7 NO. 1 CAMSHAFT BEARING CAP - - Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft...

    Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Reassembly


    REASSEMBLY PROCEDURE 1. INSTALL NEEDLE ROLLER BEARING (a) Coat the needle roller bearing with gear oil and install it to the No. 2 output shaft. 2. INSTALL REVERSE DRIVEN GEAR (a) Coat the reverse driven gear with gear oil and install it to the No...

    Categories

    Fuel-Filler Lid and Cap

    WARNING

    When removing the fuel-filler cap, loosen the cap slightly and wait for any hissing to stop, then remove it

    Fuel spray is dangerous. Fuel can burn skin and eyes and cause illness if ingested. Fuel spray is released when there is pressure in the fuel tank and the fuel-filler cap is removed too quickly.

    read more

     
    Copyright © 2026 www.toyaris4.com