Toyota Yaris: Switches and Controls / Hazard Warning Flasher

Toyota Yaris XP210 (2020-2026) Owner's Manual / When Driving / Switches and Controls / Hazard Warning Flasher

The hazard warning lights should always be used when you stop on or near a roadway in an emergency.

The hazard warning lights warn other drivers that your vehicle is a traffic hazard and that they must take extreme caution when near it.

Toyota Yaris. Hazard Warning Flasher

Depress the hazard warning flasher and all the turn signals will flash. The hazard warning indicator lights in the combination meter flash simultaneously.

Toyota Yaris. Hazard Warning Flasher

 

  • The turn signals do not work when the hazard warning lights are on.
  • Check local regulations about the use of hazard warning lights while the vehicle is being towed to verify that it is not in violation of the law.

    Rear Window Defogger

    The rear window defogger clears fog from the rear window. The ignition must be switched ON to use the defogger. Press the switch to turn on the rear window defogger...

    Brake

    ..

    Other information:

    Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Inspection


    INSPECTION PROCEDURE 1. INSPECT AUTO HIGH BEAM SWITCH (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition H47-5 (+B) - H47-2 (E) Auto high beam switch off 10 kΩ or higher H47-5 (+B) - H47-2 (E) Auto high beam switch on Below 1 Ω If the result is not as specified, replace the auto high beam switch...

    Toyota Yaris XP210 (2020-2026) Reapir and Service Manual: Rain Sensor Malfunction (B1400)


    DESCRIPTION This DTC is stored when the rain sensor detects an internal malfunction. DTC No. Detection Item DTC Detection Condition Trouble Area Memory DTC Output from B1400 Rain Sensor Malfunction IG power source voltage is 9...

    Categories

    Turning the Engine Off

    Stop the vehicle completely. Manual transaxle: Shift into neutral and set the parking brake.

    Automatic transaxle: Shift the selector lever to the P position and set the parking brake.

    Press the push button start to turn off the engine. The ignition position is off.

    read more

     
    Copyright © 2026 www.toyaris4.com